ATV12H075M2TQ Schneider Electric Industrial Automation Components

Product Details

• Electrical Connection
  Terminal 3.5 mm², AWG 12 L1, L2, L3, U, V, W, PA, PC)
• Product Specific Application
  Simple machine
• IP Degree Of Protection
  IP20 without blanking plate on upper part
• Noise Level
  0 dB
• Continuous Output Current
  4.2 A 4 kHz
• Motor Power Kw
  0.75 kW
• Physical Interface
  2-wire RS 485 for Modbus
• Assembly Style
  With heat sink
• Speed Drive Output Frequency
  0.5…400 Hz
• Time Constant
  20 ms +/- 1 ms for reference change
• Product Destination
  Asynchronous motors
• Speed Range
  1…20
• Height
  5.12 in (130 mm)
• Nominal Switching Frequency
  4 kHz
• Discrete Output Number
  2
• Marking
  CE
• Product Or Component Type
  Variable speed drive
• Maximum Horse Power Rating
  1 hp
• Connector Type
  1 RJ45 (on front face) for Modbus
• Range Of Product
  Altivar 12
Phase
1 phase
Number Of Addresses
1…247 Modbus
Braking Torque
Up to 70 % of nominal motor torque without braking resistor
Discrete Input Type
Programmable LI1...LI4 24 V 18...30 V
Depth
5.17 in (131.2 mm)
Built-In Fan
Without
Analogue Input Number
1
Minimum Switching Current
5 mA 24 V DC logic relay
EMC Filter
Integrated
Supply Frequency
50/60 Hz +/- 5 %
Maximum Transient Current
6.3 A 60 s
Insulation
Electrical between power and control
Analogue Output Number
1
Motor Starter Type
Variable speed drive
Prospective Line Isc
1 kA
Quantity Per Set
Set of 14
Communication Port Protocol
Modbus
Tightening Torque
7.08 lbf.in (0.8 N.m)
Transient Overtorque
150…170 % of nominal motor torque depending on drive rating and type of motor
Component Name
ATV12
[Us] Rated Supply Voltage
200...240 V - 15...10 %
Transmission Frame
RTU for Modbus
Output Voltage
200...240 V 3 phase
Discrete Input Number
4
Width
2.83 in (72 mm)
Braking To Standstill
By DC injection, <30 s
Net Weight
1.76 lb(US) (0.8 kg)
Linearity Error
+/- 0.3 % of maximum value analogue input
Operating Position
Vertical +/- 10 degree
Switching Frequency
2...16 kHz adjustable 4...16 kHz with derating factor
Supply
Internal supply for reference potentiometer 5 V DC 4.75…5.25 V), <10 mA overload and short-circuit protection Internal supply for logic inputs 24 V DC 20.4…28.8 V), <100 mA overload and short-circuit protection
Discrete Output Type
Logic output LO+, LO- Protected relay output R1A, R1B, R1C 1 C/O
Sampling Duration
20 ms +/- 1 ms logic input 10 ms analogue input
Frequency Resolution
Analog input converter A/D, 10 bits Display unit 0.1 Hz
Line Current
10.2 A 200 V 8.5 A 240 V
Analogue Output Type
AO1 software-configurable voltage 0...10 V 470 Ohm 8 bits AO1 software-configurable current 0...20 mA 800 Ohm 8 bits
Motor Slip Compensation
Preset in factory Adjustable
Discrete Input Logic
Negative logic (sink), > 16 V, < 10 V 3.5 kOhm Positive logic (source), 0...< 5 V, > 11 V
Asynchronous Motor Control Profile
Quadratic voltage/frequency ratio Voltage/frequency ratio (V/f) Sensorless flux vector control
Variable Speed Drive Application Selection
Mixer Commercial equipment Other application Commercial equipment Ironing Textile
Analogue Input Type
Configurable current AI1 0...20 mA 250 Ohm Configurable voltage AI1 0...10 V 30 kOhm Configurable voltage AI1 0...5 V 30 kOhm
Acceleration And Deceleration Ramps
U Linear from 0 to 999.9 s S
Transmission Rate
4800 bit/s 9600 bit/s 19200 bit/s 38400 bit/s
Maximum Switching Current
2 A 250 V AC inductive cos phi = 0.4 L/R = 7 ms logic relay 2 A 30 V DC inductive cos phi = 0.4 L/R = 7 ms logic relay 3 A 250 V AC resistive cos phi = 1 L/R = 0 ms logic relay 4 A 30 V DC resistive cos phi = 1 L/R = 0 ms logic relay
Communication Service
Read holding registers (03) 29 words Write single register (06) 29 words Write multiple registers (16) 27 words Read/write multiple registers (23) 4/4 words Read device identification (43)
Protection Type
Line supply overvoltage Line supply undervoltage Overcurrent between output phases and earth Overheating protection Short-circuit between motor phases Against input phase loss in three-phase Thermal motor protection via the d

ATV12H075M2TQ Related Documents